Electrical Connection - Miele DA 5330 D Operating And Installation Instructions

Electrical connection

,
All electrical work should be
undertaken by a suitably qualified
and competent person in strict
accordance with current national
and local safety regulations
(BS 7671 in the UK).
Installation, repairs and other work
by unqualified persons could be
dangerous, for which the
manufacturer cannot be held liable.
Ensure power is not supplied to the
appliance until after installation or
repair work has been carried out.
Do not connect the appliance to the
mains electricity supply by an
extension lead. These do not
guarantee the required safety of the
appliance.
The connection data is given on the
data plate. This is visible when the
grease filters have been removed.
Ensure that this data matches the
household mains supply.
This appliance requires two electrical
mains cables. Each one must be
connected via a suitable isolator or a
double pole fused spur connection unit
which complies with national and local
safety regulations. Their On-Off
switches should be easily accessible
after the appliance has been built in.
When switched off there must be an
all-pole contact gap of 3 mm in each
switch (including switch, fuses and
relays according to EN 60 335).
26
If these switches are not accessible
after installation (depending on
country), an additional means of
disconnection must be provided for all
poles.
For extra safety it is advisable to install
a residual current device (RCD) with a
trip current of 30 mA.
Important
U.K., IRL, NZ, ZA: This appliance is
supplied for connection to an a.c.
230 V single phase 50 Hz supply.
AUS: This appliance is supplied for
connection to an a.c. single phase
240 V, 50 Hz supply.
The wires in the mains lead are
coloured in accordance with the
following code:
Green/yellow = earth
Blue = neutral
Brown = live
WARNING:
THIS APPLIANCE MUST BE
EARTHED