Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Miele DA 5320 W
Summary of Contents for Miele DA 5320 W
- Page 1 Operating and Installation instructions Rangehood DA 5320 W en - AU, NZ To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Miele|home ........ -
Page 3: Caring For The Environment
Caring for the environment Disposal of the packing Disposal of your old appliance material or machine The transport and protective packing Electrical and electronic appliances / has been selected from materials which machines often contain materials are environmentally friendly for disposal which, if handled or disposed of and can normally be recycled. -
Page 4: Warning And Safety Instructions
Warning and Safety instructions This appliance is not suitable for This appliance complies with all outdoor use. relevant local and national safety This appliance is not intended for requirements. Inappropriate use use by persons (including children) can, however, lead to personal injury with reduced physical, sensory or and damage to property. -
Page 5: Technical Safety
Faulty components must only be the data plate correspond with the replaced by genuine Miele original on-site electricity supply, otherwise the parts. The manufacturer can only appliance could be damaged. Consult guarantee the safety of the appliance a qualified electrician if in doubt. - Page 6 Warning and Safety instructions Do not connect the appliance to the Using at the same time as other mains electricity supply by a heating appliances that depend on multi-socket unit or an extension lead. the air from the room These do not guarantee the required safety of the appliance (e.g.
- Page 7 Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
-
Page 8: Correct Use
Warning and Safety instructions Correct use Do not use the rangehood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the rangehood. To avoid the danger of into the appliance and hindering its fire, do not flambé... - Page 9 Safety regulations prohibit the fitting of a rangehood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from Miele or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
-
Page 10: Guide To The Appliance
Guide to the appliance... -
Page 11: Guide To The Appliance
(optional accessory) k Touch control for the run-on 4 panels are required for the option DA 5320 W. These ensure optimum To activate the run-on option. The fan edge extraction of cooking vapours can be set to continue running, and to above an induction or ceramic cooktop. -
Page 12: Description Of The Functions
Description of the functions The rangehood works with ..air extraction: The air is drawn in and cleaned by the grease filters and directed outside. Having a non-return flap fitted in the ducting ensures that air, once ducted to the outside, cannot get back into the room again. -
Page 13: Miele|Home
Miele electric cooktop with onset controls. This module must be installed by a For communication to take place, the... -
Page 14: Operation
Operation To switch the fan on Automatic switch-off of the Intensive setting You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III. ^ Press the On/Off control. ^ To set this option, both the fan and the cooktop lighting must be The fan runs at power level "II". -
Page 15: Run-On Option
Operation Run-on option It is advisable to leave the fan running for a few minutes after cooking has finished to neutralise any lingering The indicator lamps for fan power levels odours in the air. I and IV will flash if the automatic The fan can be set to switch off switch-off for the Intensive setting is not automatically after either 5 or 15... -
Page 16: To Switch The Cooktop Lighting On
Operation To switch the cooktop lighting Safety cut-out Should the rangehood be left on, the fan will switch off automatically after 10 The cooktop lighting can be switched hours. The lighting will remain on. on and off independently of the fan. ^ Briefly press the cooktop lighting ^ Pressing the On/Off control will control to switch on the cooktop... -
Page 17: Filter Operating Hours Counter
Operation Filter operating hours counter Reading the filter operating hours counter The number of hours the appliance has been in operation is stored in memory. To check the percentage of time set already used: The operating hours counter tells you when the grease filters need to be cleaned. - Page 18 Operation Altering the filter operating hours counter The filter operating hours counter is set at 30 hours. This can be lengthened or The – / + indicator lamps show the time shortened to suit the type of cooking which has been set: you do.
-
Page 19: Cleaning And Care
A range of Miele branded cleaning and conditioning agents are available to Important for appliances with order through your Miele Chartered stainless steel housing Agent, from Miele, or via the internet at www.miele-shop.com. (This infomation does not apply to the controls) Housing... -
Page 20: Grease Filters
Cleaning and care Important for appliances with An oversaturated filter is a fire lacquered housing hazard. (special order finish) If decor panels are fitted as an optional It is very difficult to clean this type of extra, these need to be removed first. surface without causing minor marks to the surface material. - Page 21 ^ Do not wash at more than 65 °C. If a approximately 3 seconds to reset the operating hours counter. Miele dishwasher is being used, The indicator lamp will go out. select the Sensor wash programme. ^ Use a mild dishwasher detergent.
-
Page 22: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the rangehood from the mains supply. Ensure that: – it is switched off at the isolator, or – it is switched off at the wall socket and the plug is withdrawn, or –... -
Page 23: After Sales Service
– your Miele Chartered Agent or – Miele You will find the telephone number and address of Miele on the back cover of the manual. Please quote the model and serial number when contacting Miele. These... -
Page 24: Appliance Dimensions
Appliance dimensions DA 5320 W... -
Page 25: Safety Distance Between Cooktop And Rangehood (S)
650 mm above an open grill or deep fat fryer, 650 mm above gas cooktops. If this rangehood is installed above a Miele Wok CS 1028 CombiSet appliance, a minimum safety distance of 760 mm must be maintained between the burner and the lower edge of the rangehood. -
Page 26: Installation
Installation Assembly parts... - Page 27 Installation a 3 protective sheets for use when fitting the tower. b 2 hose clips 2 screws 3.9 x 7.5 mm for securing the exhaust ducting. for securing the tower. c 1 reducing collar for exhaust ducting C 150 mm. d Telescopic wall bracket for securing the rangehood to the 1 lever...
-
Page 28: Installation Instructions
Installation Dismantling Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as "Appliance dimensions" and the described on the installation sheet. -
Page 29: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation, an additional means of undertaken by a suitably qualified disconnection must be provided for all and competent person in strict poles. accordance with current national For extra safety, it is advisable to install and local safety regulations. -
Page 30: Operation With Control Module Dsm 400
Operation with Control module DSM 400 The Miele DSM 400 Control module can Installation be used to combine the rangehood with other components. It enables the following: Potential free connection This is used for controlling another appliance with the help of the rangehood's On/Off button s. -
Page 31: Connection For Air Extraction
Connection for air extraction Important: To avoid the danger If the exhaust ducting is secured to of toxic fumes, please observe the the exhaust stub by a hose clip, Warning and Safety instructions. ensure that it is fitted correctly and is This is especially crucial when using not askew. - Page 32 Connection for air extraction For exhaust ducting with a diameter of 200 mm, the following accessories are required: – Exhaust hose DAS 200 – Exhaust grille DFG 200, for mounting on the external wall. *Lead flashing – Roof ducting DDF 200, for mounting on a sloping tiled roof.
-
Page 33: Technical Data
Total rated load - DA 5320 W ....600 W Fan......500 W Cooktop lighting - DA 5320 W . - Page 36 Alteration rights reserved / 4511 M.-Nr. 09 203 320 / 01...