Recording Methods; Notes On Recording; Recording Formats; Connecting External Equipment - Panasonic WR-201E Design Handbook

PRODUCTS
4
WU-ZM001E
MAJOR OPERATING CONTROLS & TERMINALS
Front View
Rear View
56

RECORDING METHODS

Notes on recording

• Sound data is recorded to the SD memory card. Do not remove the SD memory card during recording.
• You can switch the time display between elapsed recorded time and remaining recording time by pressing the SCHEDULE
switch while recording.
Press the SCHEDULE switch
Press the SCHEDULE switch
Elapsed recorded time
Note:
The elapsed/remaining time displayed during recording is not exact. There might be some difference between the displayed time and the actual one.
• The recorded sound data file is saved to the "ZM001" folder on the SD memory card.
* Folders are generated automatically when the SD memory card is formatted.
SD memory card
PRIVATE
MEIGROUP

Recording formats

The following sound data formats can be recorded to this Sound Message Unit.
Item Description
File format Linear PCM (WAV)
Audio sample rate 44.1 kHz
Audio sample size 16 Bit
Stereo/Mono Mono

Connecting external equipment

External equipment is connected as shown below.
• Connecting to REC IN
Connect the external equipment's audio signal out or microphone to this jack. Set the audio signal level (LINE/MIC) to match the
device that you are connecting.
• Connecting to PHONES
Connect headphones to this jack.
Note:
REC IN terminal of this unit is for unbalanced
input. The audio message could not be recorded
if the input is balanced. Please use microphones
or equipment of unbalanced output.
PRODUCTS
WU-ZM001E
Remaining recording time
PSS
ZM001
MESSAGE EMG
SELECT 1 2 3 1 2
SCHEDULE MENU ENTER CANCEL REC IN PHONES OUTPUT
RESET CLK ADJ.
WU-ZM001
SD CARD
Microphone,etc.
Headphone
4
57