Remote Microphone (Wr-210Ae) Connection; Speaker Connection - Panasonic WR-201E Design Handbook

CONNECTIONS
3
WA-MA120N/WA-MA240N

Remote Microphone (WR-210AE) Connection

• Up to four Remote Microphone units can be connected. For multiple connections, priority connection between Remote
Microphones is required. For more information, consult the operating instructions of the Remote Microphone.
WA-MA120N
or
WA-MA240N
Important 1
LINE OUT H
LINE OUT C
DC 24V
• Confirm that the -22dBV (RM), -65dBV (MIC) switch is set to -22dBV (RM). If it isn't change the switch setting to -22dBV (RM).
Important 1:
Make this connection if you want to use call tones.
Important 2:
To perform 2-channel announcement from the Remote Microphone, connect the CALL terminal to any one of the C4 to C10 terminals of the
Remote Microphone. The individual switch (4-10) on the Remote Microphone that corresponds to the terminal number you connect to can be
used to switch to zone 1 interrupt during 2-channel announcement.
Important 3:
If you want the Amplifier to enter the operation mode when activation control is imposed from the Remote Microphone, branch from the cable
connected to the Remote Microphone's CONT terminal and connect to the Amplifier's OPERATE ON terminal.
20
Important 3
Important 2
Connect to
any terminal
Remote Microphone
CONT C3 C4 to 10
CKO C2
C1
0V CALL SIGN DOWN
CALL SIGN UP

Speaker Connection

• Use the connections shown below for connecting high-impedance or low-impedance loudspeakers.
Caution:
High-impedance and low-impedance loudspeakers cannot be connected at the same time. When using high-impedance loudspeakers, use
either 100 V or 70 V.
WA-MA120N
or
WA-MA240N
(WR-210AE)
Important 1:
When you want high-impedance loudspeaker output to by 70 V, change the position of the jumper as shown in the illustration. The factory
preset is 100 V.
Important 2:
Make sure that the parallel composition impedance of high-impedance loudspeakers does not fall below the values shown in the table below.
Speaker Connection
Method
Speakers connected to
ZONE 1 or DIRECT OUT
only
Speakers connected to
multiple zones and DIRECT of all zones
OUT, and use
simultaneously
Important 3:
Make sure that the parallel composition impedance of low-impedance loudspeakers does not fall below 4 Ω. Up to two 8 Ω speakers or four
16 Ω speakers can be connected in parallel.
WA-MA120N/WA-MA240N
Important 1
Monitor,
etc.
Important 3
Low-impedance Loudspeakers
(up to 4Ω)
Important 2 High-impedance Loudspeakers
(up to the impedance shown in the table below)
Conditions Minimum Composition Impedance
WA-MA120N
100 V 70 V
Composition impedance 83 Ω 42 Ω
for one zone (120 W) (120 W)
Composition impedance 83 Ω 42 Ω
(120 W) (120 W)
CONNECTIONS
3
Zone 1
Zone 2
Zone 3
WA-MA240N
100 V 70 V
42 Ω 21 Ω
(240 W) (240 W)
42 Ω 21 Ω
(240 W) (240 W)
21