Line1,2, Input2,3, Rec Out, Ins In/Out Connections; Emg, Tel Paging, Input1 Connections - Panasonic WR-201E Design Handbook

CONNECTIONS
3
WA-MA120N/WA-MA240N

LINE1,2, INPUT2,3, REC OUT, INS IN/OUT Connections

• Use the connections shown below for a microphone or recording/playback equipment, effect device that is not equipped with
activation control (no-voltage make contact).
• For information about connecting INPUT1, refer to page 19.
WA-MA120N
or
WA-MA240N
Microphone, etc.
Audio Signal Source Equipment
(IC player, etc.)
• Change the INPUT1-3 MIC/ LINE switches setting in accordance with the equipment being connected.
• When connecting an effect device, remove the plug inserted in the RCA pin jack.
• Turn the INPUT1-3 +16 V ON/OFF switches on only when using an electret condenser microphone.
Important:
• Leaving this setting on when for any other type of connection will cause malfunction of the connected device or equipment.
• Changing this setting also can cause noise, so be sure to use the INPUT1-3 knobs on the front of the Amplifier to reduce volume before
changing this setting.
18
Effect Device
BGM Player (graphic equalizer, etc.)
(CD player, etc.)
Recording/
Playback Equipment
(cassette deck, etc.)

EMG, TEL PAGING, INPUT1 Connections

• Use the connections shown below for emergency announcement equipment or PBX, microphone that is equipped with
activation control (no-voltage make contact).
WA-MA120N
or
WA-MA240N
Emergency Announcement
Equipment
PBX, etc.
• Change the INPUT1 MIC/ LINE switches setting in accordance with the equipment being connected.
• Turn the INPUT1 D-OUT switch on when the INPUT 1 signal is being output from INPUT D-OUT for 2-channel announcement.
• Be sure to connect the connected device's no-voltage make contact terminal to each activation control terminal [CNT]. If they
are not connected, announcement priority control will not work or the audio signal of the equipment will not be output.
• When using a call tone, be sure to make contact with each input equipment's not-voltage make contact and then activate the
call tone. The call tone will not be announced if it is activated first.
• Turn the INPUT1 +16 V ON/OFF switch on only when using an electret condenser microphone.
Important:
• Leaving this setting on when for any other type of connection will cause malfunction of the connected device or equipment.
• Changing this setting also can cause noise, so be sure to use the INPUT1 knob on the front of the Amplifier to reduce volume before changing
this setting.
CONNECTIONS
WA-MA120N/WA-MA240N
Microphone, etc.
Talk Switch (no-voltage make contact)
CALL SIGN Rising Switch
(no-voltage make contact)
CALL SIGN Falling Switch
(no-voltage make contact)
3
19