Standard Disassembly Drawings; Troubleshooting - Samsung WF365BTB series Service Manual

3-2. sTanDaRD Disassembly DRawings

► This is a standard disassembly diagram and may differ from the actual product.
Use this material as a reference when disassembling and reassembling the product.
Part
Disassembling and
Repairing the Rear
motor
10 _ Removal and Reassembly
figure
HALL SENSOR
MOTOR WIRE
4 Check Points for Troubleshooting
1. Check if there is any alien substance between the Rotor and the Stator.
2. Check if the motor power (Blue, White, Red) wire is connected.
3. Check if the Hall Sensor wire is connected.
The order of the motor wires is Blue, White, and Red from the right. Check if the
resistance between Blue-White, White-Red, and Red-Blue is equal to 15Ω.
Description
1. Remove the 2 screws holding the Back-Cover
at the back of the washing machine and
separate the Back-Cover pushing it downwards
(Assemble it by lifting it upwards,)
2. After separating the Back-Cover, remove the
M19 nut holding the Motor.
To remove it, turn it counter-clockwise. As the
Motor also rotates if the nut is turned slowly,
torque it quickly and firmly in a single action.
Do not remove the nut by inserting a screwdriver
into the Motor, as this may result in a problem
with the motor.
3. Remove the M19 nut and washer and then
separate the Rotor.
Since removing the rotor requires a lot of
strength due to the magnetic force of the Rotor
and it may come off suddenly, your hand or
arm may be injured by the edge of the Stator
or Frame. Therefore take precaution when
separating it.
You can separate the connector by pressing the
navel of the Housing and pulling it outside.
4. Separate the Motor Wire and Hall Sensor while
pressing the navel of the Housing.
Take precaution when you do this because the
Hall Sensor part is easily shocked.
5. Separate the 6 M10 screws. → Separate the
Assy Bracket Motor → Separate the Stator.
When removing the last of the 6 screws, hold
the Stator as it may fall when the screws are
removed.