Parts Identification; Storing And Charging The Toothbrush - Panasonic EW-DL82 Operating Instructions Manual

Parts identification
A Main unit
1 Toothbrush shaft
2 Waterproof rubber seal
3 Power switch
4 Mode indicator
5 Charge status lamp (
6 Battery capacity lamp
( )
B Stain care brush
7 Extra fine side bristles
8 High‑density bristles
9 Tongue cleaner
 Identification ring
Characteristics of brush bristles (8)
The bristles in the center (high‑density bristles) are arranged in a
diamond shape, which is designed for stain care.
8
EW-DL82_EU.indb 8
C Charger (RE8-52)
(The shape of the power
plug differs depending on
the area.)
 Cord
)  Power plug
 Charger base
 Charging section
 Main unit guide
 Brush head storage
Accessory
D Carrying case
Storing and charging the toothbrush
• If the toothbrush stops operating when first using it (immediately
after purchasing it, or after not using it for 3 months or more) or
during use, charge the main unit.
• Adequate ambient temperature for charging is 5 °C – 35 °C.
The battery may not charge properly or not at all under extreme
low or high temperatures.
• You can keep the main unit attached on the charger when not in
use to maintain the full battery capacity. It will not overcharge the
main unit.
• The main unit may become warm during use and charging.
However, this is normal.
1
1
Place the charger on a stable
horizontal surface such as
countertop.
2
2
Align the main unit so it is
facing forward, and set it
straight into the charging
section.
3
3
Insert the power plug into the
household outlet.
• The charge status lamp glows and
the charging will start.
• Charging cannot start when the main
unit is tilted or the bottom of the main
unit is not in contact with the
charging section.
2
1
3
2013/10/15 10:46:20