Using Surround Modes - JVC RX-5032VSL Instructions Manual

Creating Realistic Sound Fields
Make sure that you have set the speaker information correctly (see pages 15 and 16).
• If only the front speakers are connected, you cannot use Surround/DSP modes.
• You cannot use DSP modes if no surround speakers are connected.
• Do not change the speaker setting while using any Surround/DSP modes; otherwise, the Surround/DSP modes may be
canceled when you deactivate the speakers required for the Surround/DSP modes.
RX-6030VBK and RX-6032VSL only:
• When DVD MULTI is selected as the source, you cannot use Surround/DSP modes (SURROUND and DSP buttons do not
work).
Front panel
DSP SURROUND
RX–6030V
STANDBY
SURROUND
STANDBY/ON
DSP
DIGITAL AUTO
ANALOG
LINEAR PCM
DIGITAL
SURROUND/DSP
OFF
DVD MULTI DVD
D I G I T A L
PHONES
D I G I T A L SPEAKERS SUBWOOFER OUT
P R O L O G I C
S U R R O U N D
ON/OFF ON/OFF
SURROUND/DSP OFF

Using Surround Modes

Speaker layouts required for Surround modes are as follows:
• 5 channels
(Front, center, and surround speakers
are connected.)
• 4 channels
(Front and surround speakers are
connected.)
• 3 channels
(Front and center speakers are
connected.)
7 Operating procedure
1
Select the source you want to listen to and
start playing.
• When playing back software encoded with Dolby Digital
and DTS Digital Surround, select the digital input mode
(see page 17).
26
AUDIO/VIDEO CONTROL RECEIVER
DIMMER
INPUT DIGITAL
SPK 1 2 ONE TOUCH OPERATION BASS BOOST INPUT ATT EON RDS SLEEP
L C R
PRO LOGIC DSP H.PHONE AUTO MUTING TUNED STEREO TA NEWS INFO VOLUME
S.WFR LFE
LS S RS
CH– INPUT ANALOG
INPUT ATT
VCR TV SOUND CD TAPE/CDR FM AM
SOURCE NAME
FM/AM TUNING FM/AM RESET FM MODE MEMORY
Remote control
DISPLAY MODE
SURROUND
REMOTE CONTROL RM-SRX
2
Press SURROUND.
The appropriate Surround mode will be activated
according to the incoming signal.
• DOLBY DIGITAL:
Activated if you are playing back multi-channel
software encoded with Dolby Digital.
• DTS SURROUND:
Activated if you are playing back software encoded
with DTS Digital Surround.
• PL II MUSIC* or PL II MOVIE:
Activated if you are playing back any software other
than the above. (The last one selected will be
activated.)
The PRO LOGIC II indicator lights up on the
display.
Press SURROUND repeatedly to select the one
appropriate for the source.
* When "PL II MUSIC" is selected, you can select Panorama control
to enjoy "wraparound" sound effect with side-wall image (see
page 19 for the setting procedure).
Notes:
• When "DOLBY DIGITAL" or "DTS SURROUND" is selected with
no surround speakers connected, the surround sounds are
downmixed and output from the front speakers.
• For the available Surround modes according to the input signals,
see "Available Surround/DSP modes for each input signal" on
page 25.
To adjust the speaker output level and select Panorama
control for Pro Logic II Music, see pages 19 to 21.
The adjustment is memorized for each source (except for
Panorama control).
To turn off Surround mode, press SURROUND/DSP OFF.
DSP
SURROUND/DSP
OFF
6030J