Mounting The Cutting Attachment - Stihl FS 260 R Instruction Manual

English
Mounting the Cutting
Attachment
Placing power tool on the ground
Shut off the engine.
N
Lay your power tool on its back so
N
that the cutting attachment
mounting face is pointing up.
Mounting Hardware for Cutting
Attachments
The mounting hardware supplied
depends on the cutting attachment that
comes as original equipment with the
new machine.
Machine supplied with mounting
hardware
Mowing heads and metal cutting
attachments may be mounted.
20
3
4
5
1
2
Depending on the cutting attachment, it
may be necessary to use the nut (3),
rider plate (4) and thrust washer (5).
These parts are included in a kit
supplied with the machine and are also
available as special accessories.
Removing the transport lock
Pull the hose (1) off the shaft (2).
N
Machine supplied without mounting
hardware
2
Only mowing heads may be used which
mount directly to the shaft (2).
FS 240, FS 240 C, FS 240 R, FS 240 RC, FS 260 R, FS 260 RC
Blocking the Shaft
2
7
6
The output shaft (2) must be blocked
with the stop pin (6) or screwdriver (6) to
mount or remove cutting tools. These
parts come standard with the machine or
are available as special accessories.
Insert the stop pin (6) or
N
screwdriver (6) in the hole (7) in the
gearbox as far as stop – and apply
slight pressure.
Rotate shaft, nut or cutting
N
attachment until the stop pin slips
into position and blocks the shaft.
6