Clearing Learned Functions, Renamed Source Names, And Setup Manufacturer Codes - Yamaha RX-V1300RDS Owner's Manual

REMOTE CONTROL FEATURES
Clearing Learned Functions,
Renamed Source Names, and
Setup Manufacturer Codes
You can clear learned functions, renamed source names
and set up manufacture codes. You can also revert the
remote control to the factory setting.
1
Press CLEAR by using a ballpoint pen or
similar object.
CLEAR
Note
• If you do not press any button within 30 seconds during steps 2
and 3, the clearing process is canceled. If this happen, start over
from step 1.
2
Press u / d to select the clear mode.
The mode is shown in the display window in the
following order:
PRESET
50
0108V1300_45-55_EN-GB.p65
+
TV VOL
CH CH
TV MUTE
+
–
SELECT
PRESET
TV VOL
–
(L: name of a component) Clears
all learned functions for the
component area.
Clears all learned functions for
this unit control area.
Clears all learned functions.
Clears all renamed source names
in the display window.
Clears all programmed functions
including setup manufacturer
codes. This returns to the factory
settings.
50
3
Press and hold CLEAR again for about 3
seconds.
"C:OK" appears in the display window.
CLEAR
Note
• "C:NG" appears in the display window if the operation is
unsuccessful. In this case, start over from step 2.
4
Press CLEAR to exit from the clearing mode.
CLEAR
Note
• "ERROR" appears in the display window when pressing
buttons other than indicated in each step, or more than one
button at once.
2002.11.07, 12:09