Connecting The Antennas - Yamaha RX-V1300RDS Owner's Manual

Connecting the Antennas

Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal
strength.
Connect each antenna correctly to the designated terminals.
AM loop antenna
(included)
COMPONENT VIDEO
P / C P / C Y
R R B B
VD
BL
SAT
NITOR
UT
W
TUNER
AM
ANT
GND
FM ANT
C
75Ω
UNBAL.
Ground (GND terminal)
For maximum safety and minimum
C
interference, connect the antenna GND
terminal to a good earth ground. A good
earth ground is a metal stake driven into
moist earth.
I Connecting the indoor FM
antenna
Connect the included indoor FM antenna to the 75Ω
UNBAL. FM ANT terminal.
0103V1300_10-20_EN-GB.p65
Indoor FM
antenna
(included)
19
I Connecting the AM loop antenna
1
Set up the AM loop antenna, then connect it.
2
Press and hold the tab to insert the AM loop
antenna lead wires into the AM ANT and
GND terminals.
3
Orient the AM loop antenna for the beat
reception.
y
• The AM loop antenna can be removed from the stand and
attached to a wall, etc.
Notes
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
A properly installed outdoor antenna provides clearer
reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may improve the
quality. Consult the nearest authorized YAMAHA
dealer or service center about the outdoor antennas.
2002.11.07, 12:07
CONNECTIONS
19