Panasonic WV-CL924A Operating Instructions Manual page 30

6-2. VS Gen-lock Mode (EXT(VS))
1. Move the cursor to the SYNC parameter and select
INT.
2. Connect the coaxial cable for the composite sync
or composite B/W video signal to the gen-lock
input connector.
3. Confirm that the parameter INT changed to EXT
(VS) on the menu.
Caution: The gen-lock input signal should meet
with EIA RS-170 specifications and should not
contain jitter, such as a VCR playback signal ,
as it could disturb synchronization.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON (DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
END SET UP ENABLE
4. After confirming that the cursor is on EXT (VS),
press . The phase adjustment menu appears
on the monitor.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON (DNR-H)
SENS UP OFF
SYNC EXT(VS)
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
END SET UP ENABLE
H PHASE
RET
5. Supply the video output signal of the camera to be
adjusted and the reference gen-lock input signal to
a dual-trace oscilloscope.
6. Set the oscilloscope to the horizontal rate and
expand the horizontal sync portion on the oscillo-
scope.
7. Move the cursor to H PHASE.
8. Adjust the horizontal phase by pressing
. The adjustable range is 0 - 2.0µs.
6-3. Line-lock Sync Mode (LL)
Note: The line-lock (LL) sync mode is not available
when the camera operates on DC power.
1. Move the cursor to the SYNC parameter and select
LL.
Note: The settings in this menu can be made only
when the multiplexed vertical drive signal
(VD2) is not supplied to the camera.
-31-
** SYNC **
........I
- +
END
or