Tail Wheel - Kangke HOWARD DGA 15 Assembly Manual

Use blue thread locker to secure horn bolts.
Attach Elevators to stabilizers, again using the
same procedure as you did with the ailerons.

TAIL WHEEL

Put together the tail wheel assembly. File or
dermal a flat spot on the top of the wheel wire
and on the outside end of the tire axle so that the
wheel collars will lock on and will not move
about.
Attach the assembly to the fuselage with the
screws provided ensuring that the swivel point is
directly over the hinge point of the rudder.
Attach the springs and rudder attachment, mildly
stretch the spring assembly back over the rudder
and attach to the rudder as shown below.
TAIL SERVOS
Install elevator servos on each side of the
fuselage. Mount the servo arms pointing upward.
Extend the servo leads with 24" servo extension
wires and place inside the fuselage. An option is
to you a Servo Reverser Harness (which allows
you to connect 2 servos to one receiver port with
one servo reversed). Position the extension wires
to suit and temporary secure the loose end of the
extension wires at the receiver end. (Option:
secure the extension wires in the fuselage if so
desired). Measure, bend and connect push rod /
clevis / keepers as shown in picture below.
8