Wing Assembly - Kangke HOWARD DGA 15 Assembly Manual

WING ASSEMBLY

Start by removing aileron and flap from
packaged wing. Remove hinges.
Place 2 pins in each hinge as shown and reinsert
the hinges into flap and aileron.
Attach flap and aileron onto wing panel,
ensuring that they are properly aligned and the
end spaces are minimal and equal.
CAREFULLY apply THIN CA glue to each of
the hinges, ensuring that the flap and aileron
surfaces are FLUSH with the wing.
Apply THIN CA to the bottom side of the hinges.
Cleanup and CA spills with CA de-bonder or
Acetone. Work quickly and have plenty of paper
towels available as well as lacquer thinner.
Leaving Acetone will cause a white film.
HINT:
Refer to the following picture. I used a VERY
FINE bulb dispenser for the CA glue. This helps
prevent accidental splashes onto the covering.
Install both the flap and aileron servos with the
screws provided with the servos.
Use the pull string to work the servo wires
through the wing and out the exit hole in the root
rib.
HINT: - Temporarily hook up your Aileron and
Flap servos to your receiver and turn on the radio.
This will help you center the ailerons and
confirm proper operation of ailerons and flaps at
this point rather than at final assembly time.
Install the aileron and flap control horns.
The aluminum horns included with this kit only
require you to locate the proper position, drill
one hole for the bolt and assemble.
I would suggest using a drop of blue lock tight
on the horn bolt to prevent it from becoming
loose.
(Remember- the flaps work differently to
ailerons, so the horns for them will be mounted
on the same side of the servo vs. ailerons which
are usually mounted to the wing tip side of the
servo).
Fabricate the control rods and attach to servos
and control horns.
HINT:- Use a small clamp to keep ailerons in
neutral position while hooking them up, then use
the clamp to keep the flap and aileron in line.
The kit includes 4 strips of Ultra coat covering
which may be used to cover the aileron and flap
4