Advertisement
By NCK Team
TCT
L2 Repair Document
Mobile Limited
2). Please use hot wind gun to heat up LCD module around the four edges (Temperature: 100℃, Air Level: 3,
Height:5-10mm, Time:<60s), and then use plastic flake to push the LCD model through the hole as below.
swipe along the four edges of LCD model and seperate it from furnished front casing slowly and
carefully;
Rev.
Page
1.0
26/39
one touch 992 Level 2 Repair Document
All rights reserved. Transfer, copy, use or communication of this file is prohibited without authorization.
Advertisement
