Addition Or Deletion Of Remote Controls; Replacing Battery In Remote Control; Wireless Switch; Delete All Remote Controls - BOXER ZTGD-800 User Manual

Addition or deletion of remote controls

Addition
To add more remote controls, press the "P" button and hold
it down for 6 seconds, until LED no. 7 flashes.
Press the "+" button, so that LED no. 7 shines continuously.
Press the required button on the remote control twice. When
the door opener has received the signal from the remote
control twice, all lamps will light up except LED no. 7, which
will flash. Then press the "P" button to save the setting.

Delete all remote controls

Press the "P" button and hold it until LED no. 7 flashes.
Press the "-" button and hold it down for 3 seconds. The
memory will now have been cleared. None of the remote
controls will operate the door opener any longer.
Each remote control can operate up to 3 door openers, so a
function button can be programmed for each motor unit.

Replacing battery in remote control

Caution!
• Incorrect battery replacement can be dangerous. Always replace with the
same battery type.
• Use longlife batteries.
• Slacken screws on rear of remote control and remove cover.
• Replace battery.
• Check alignment of poles (+/-). Place - pole on spring
• Replace cover and tighten screws.
Wireless switch (supplied ONLY with model BOXER 3000)
A wireless switch is ONLY supplied with model BOXER
3000, item no. 63003.
This switch is fitted inside the garage, so that the door can
be opened without the remote control.
It can be coded in the same way as a remote control; see
the instructions above for "Addition or deletion of remote
controls".