Advertisement
ABSOLUTE:
if you wish to set the start TIME of required
programme, or if you wish to set the TIME
the required programme end WITHIN.
RELATIVE:
if you wish delay start to be programmed
by adding hours (delay can be increase by
1 hour to a maximum of 23 hours).
FOR MORE DETAILED INFORMATION,
REFER TO "PROGRAMME START"/
"PROGRAMME END" and "DELAY
START" SECTION IN THE "PROGRAMME
SELECTION AND SPECIAL FUNCTIONS"
CHAPTER.
Press the "FLEXI LOAD" button to move
from "ABSOLUTE" to "RELATIVE" or vice
versa.
Press the "MENU" button to confirm and
move to the next step.
STEP 6
BUZZER ?
YES
(Default setting: YES)
This option allows to enable a buzzer to
signal that the wash cycle has ended.
Press the "FLEXI LOAD" button to move
from "YES" to "NO" or vice versa.
Press the "MENU" button to confirm and
move to the next step.
STEP 7
ENABLE MEMORY?
NOT AVAILABLE
Function not available for this model.
Press the "MENU" button to move to the
next step.
STEP 8
SET DEMO MODE?
NOT AVAILABLE
Function not available for this model.
Press the "MENU" button to move to the
next step.
STEP 9
DOMOTIC MODE
NOT AVAILABLE
Function not available for this model.
Press the "MENU" button to move to the
next step.
STEP 10
EXIT
MENU ?
You can exit the menu by pressing the
"MENU" button.
However, if you wish to change one of the
settings selected without going out from the
menu, you can press the "FLEXI LOAD"
button and return to start screen. By
pressing the "MENU" button you are able
to bypass each option until you reach the
option you would like to re-set.
When you are completely satisfied with your
menu selection, you may exit the menu.
Note: you can exit from the menu at any
moment, by holding the "MENU" button
for at least 5 seconds, without bypassing
each option individually until you reach
the STEP 10.
If, after the first setting you may want to make any
changes, run through the menu options again
from the beginning and change the options.
You may need to use this option to change
the time and switch from solar time to legal
time or vice versa; enter up to
("SET NEW TIME") going through step 1,
2 & 3 by pressing the "MENU" button.
Once set, the menu options will remain in the
memory of the machine even if the machine is
unplugged or if a power cut occurs.
You may return to "recommended" programme
by going out from the menu.
AUTO PROG.
1h
UNIVERSAL
You are now able to select any wash programme.
You can also set a delay start if you wish.
Where more detailed information is
required refer to the relevant section
from the following pages.
22
DESCRIPTION OF THE CONTROL PANEL
A
A
"ON/OFF" button
B
"TIME SAVER" button
C
"BOOST" button
D
"FLEXI LOAD" button
E
"MENU" button/
"DELAY START" button
DIMENSIONS:
step 4
Height
Depth
Width
Depth with door open
TECHNICAL DATA:
65
EN 50242 place load
Capacity with pans and dishes
Water supply pressure
Fuse
Power input
Supply voltage
H
I
B C D
E
F
F
Open door
G
"PROGRAMMES" buttons
H
"OPTION SELECTION" LEDs
I
DIGITAL DISPLAY
L
"PROGRAM SELECTION" LEDs
with working top
cm
85
cm
60
cm
60
cm
120
15
9 persons
Min. 0,08 - Max 0,8 MPa
(see rating plate)
(see rating plate)
(see rating plate)
23
L
G
without working top
82
57,3
59,8
117
Advertisement
