Advertisement
DESCRIPTION OF THE CONTROL PANEL
H
I
F
G
E
D
C
A
"ON/OFF" button
B
PROGRAMME DESCRIPTION
C
"PROGRAMME" buttons
D
"HALF LOAD" option button
E
"DELAY START" button
DIMENSIONS:
Height
Depth
Width
Depth with door open
TECHNICAL DATA:
EN 50242 place load
Capacity with pans and dishes
Water supply pressure
Fuse
Power input
Supply voltage
B
F
"PROGRAMME STATUS" lights /
"DELAY START" time lights
G
"OPTION SELECTION" light
H
"PROGRAMME SELECTION" lights
I
"SALT EMPTY" light
cm
82 ÷ 88,5
cm
55
cm
59,8
cm
117
15
9 persons
Min. 0,08 - Max 0,8 MPa
(see rating plate)
(see rating plate)
(see rating plate)
20
PROGRAMME SELECTION
AND SPECIAL FUNCTIONS
(Use in conjunction with programme guide)
IMPORTANT
The dishwasher has two very practical
functions:
- the "recommended" programme
(which is ideal for full load daily use)
for quick and accurate selection;
- the "Auto' Memory", function saves
any programme used at least 3 times
consecutively, so that if you regularly
use the same washing cycle
do not have to continually set the
programme thereby saving time and
effort.
A
Programme settings
Open the door and place the dirty dishes
inside the appliance.
Press the "ON/OFF" button
After pressing the "ON/OFF" button,
the indicator light which is factory set
"recommended", or the indicator light
for the "Auto' Memory" programme will
flash.
If you wish to select an option, press the
option button (the corresponding indicator
light will light up).
The option button can be selected or
deselected WITHIN 2 minutes of the
programme commencing.
Choose a programme by pressing the
corresponding button.
Close the door (after an audible signal
has sounded, the programme will start
automatically).
IMPORTANT
To select the "COLD RINSE" programme,
simultaneously press the "RAPID"
programme button and "HALF LOAD"
option button.
Programme interruption
Opening the door when a programme is
running is not recommended especially
during the main wash and final hot rinse
phases. However, if the door is opened
while a programme is running (for example,
to add dishes) the machine stops
automatically.
Close the door, without pressing any
buttons. The cycle will start from where it
left off.
WARNING!
If you open the door during the
drying cycle, an audible audio signal
you
advises you that the drying cycle has
not yet finished.
Changing a running programme
Proceed as follows to change or cancel a
running program:
Open the door.
.
Hold down the current programme button
(with the indicator light on) for at least 5
seconds. The programme indicator lights
(except for the "RAPID" programme
indicator light) will flash.
The running programme will be cancelled
and
the
indicator
"recommended" programme or the
indicator light for the
was used at least 3 times consecutively
will start to flash.
At this point a new programme can be set.
IMPORTANT
To
cancel
the
"COLD
programme,
simultaneously
down the "RAPID" programme button
and "HALF LOAD" option button.
WARNING!
Before starting a new programme,
you should check that there is still
detergent in the dispenser.
If necessary, top up the dispenser.
21
light
for
the
programme that
RINSE"
hold
Advertisement
