Chapter 4. Cabling The Switch Module And The Sfp+ Module; Connecting The Serial Console Cable; Disconnecting The Serial Console Cable - Lenovo BladeCenter Virtual Fabric 10Gb Switch Module Installation Manual

High-speed ethernet component that is installed into a bladecenter unit that supports high-speed i/o modules

Hide thumbs Also See for BladeCenter Virtual Fabric 10Gb Switch Module:

Table of Contents

Chapter 4. Cabling the switch module and the SFP+ module

This chapter describes how to cable the switch module and its optional devices.

Note: The illustrations in this document might differ slightly from your hardware.

To connect the serial console cable to the switch module, connect the serial cable to

the RS-232 serial console port of the switch module and the other end of the cable

to the console device.

To disconnect the serial console cable, grasp the connector and gently pull the

cable from the switch module.

Table of Contents