Connecting The Rj-45 Cable; Disconnecting The Rj-45 Cable - Lenovo BladeCenter Virtual Fabric 10Gb Switch Module Installation Manual
High-speed ethernet
component that is installed into a bladecenter unit that supports high-speed i/o
modules
Hide thumbs
Also See for BladeCenter Virtual Fabric 10Gb Switch Module:
- Product manual (17 pages) ,
- User manual (20 pages) ,
- Hardware maintenance manual (172 pages)
Table of Contents
Advertisement
Connecting the RJ-45 cable
The RJ-45 cable can be connected to port 11.
To connect the RJ-45 connector to the switch module, push the RJ-45 cable
connector into the port connector until it clicks into place, as shown in the
following illustration.
Disconnecting the RJ-45 cable
To disconnect the RJ-45 connector, squeeze the release tab and gently pull the cable
connector out of the switch-module connector.
Chapter 4. Cabling the switch module and the SFP+ module
21
Advertisement
Table of Contents
