Table of Contents
Advertisement
5 File server management
This chapter describes the tasks and utilities that play a role in file server management.
File services management
Information about the storage system in a SAN environment is provided in the SAN Design Reference
Guide, located on the HP web site at www.hp.com/go/SDGManuals.
Storage management utilities
The storage management utilities preinstalled on the storage system include the HP Array
Configuration Utility (ACU).
Array management utilities
Storage devices for RAID arrays and LUNs are created and managed using the array management
utilities mentioned previously. For HP Smart Arrays use the ACU.
NOTE:
The ACU is used to configure and manage array-based storage. Software RAID-based
storage systems use Microsoft Disk Manager to manage storage. You need administrator or root
privileges to run the ACU.
Array Configuration Utility
The HP ACU supports the Smart Array controllers and hard drives installed on the storage system.
To open the ACU from the storage system desktop:
NOTE:
If this is the first time that the ACU is being run, you will be prompted to select the Execution
Mode for ACU. Selecting Local Application Mode allows you to run the ACU from a Remote
Desktop, remote console, or storage system web access mode. Remote service mode allows you
to access the ACU from a remote browser.
Click Start and then click ↓. Select HP System Tools→HP Array Configuration Utility.
1.
2.
If the Execution Mode for ACU is set to Remote Mode, log on to the HP System Management
Homepage. The default user name is Administrator and the password is the Windows
Storage Server 2012 or 2012 R2 administrator password that is set by the storage system
administrator. The password is case-sensitive.
To open the ACU in browser mode:
NOTE:
Confirm that the ACU Execution Mode is set to remote service.
1.
Open a browser and enter the server name or IP address of the destination server. For example,
http://servername:2301 or http://192.0.0.1:2301.
2.
Log on to the HP System Management Homepage. The default user name is Administrator
and the default password is HPinvent!.
NOTE:
For 3000 gateway system, the default password is HPinvent!. You are not promoted
to change this password.
For the 3000 blade server, no default password is set. You must change the password
after you log in.
3.
Click Array Configuration Utility on the left side of the window. The ACU opens and identifies
the controllers that are connected to the system.
34
File server management
Advertisement
Table of Contents
