Hitachi WR 18DBDL2 Instruction Manual page 16

English
Switch panel
ON
ON
OFF
Remaining Remaining
battery battery
indicator indicator
lamp switch
State of lamp Battery Remaining Power
The battery remaining power is
enough.
The battery remaining power is a half.
The battery remaining power is nearly
empty.
Re-charge the battery soonest
possible.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
NOTE
Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
9. How to use the LED light
By pressing the light selector switch on the switch
panel, the LED light mode changes as Table 6. It is
indicated by green lamp. (Fig. 15)
To prevent the battery power consumption, turn off the
LED light frequently.
Switch panel
ON
ON
OFF
Light Remaining
section battery
switch indicator lamp
16
Fig. 14
Table 5
Fig. 15
Always-ON
mode
Panel
display
Always ON
State (turn off after
2 minutes)
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 2 minutes.
10. Tightening mode selector function (Fig. 16)
CAUTION
● Do not subject the switch panel to shock or
damage.
● Select tightening mode while the trigger switch
is released. Failure to do so could result in
malfunction.
Tightening mode
selector switch
Table 6
SW Always-OFF
interlocked mode
mode
Light only Always OFF
SW-ON
Tightening mode
indicator lamp
Fig. 16