Operating Your Locomotive In The Conventional Environment - Lionel Keystone Super Freight Owner's Manual

Conventional transformer operations
Operating your train set in the conventional environment
1. With your transformer turned off, place your train set on Lionel or Lionel-
compatible O-27 or larger track.
2. Connect the drawbar and tether between the locomotive and tender as
illustrated in Figure 6.
Figure 6. Drawbar connection
3. Power your locomotive at 8-18 volts with your alternating-current (AC)
transformer.
Power your locomotive with an alternating-current (AC) transformer only.
Caution!
Powering your locomotive with a direct-current (DC) transformer may result in
damage to sensitive electronic components.
4. Wait three to eight seconds as your locomotive determines whether it is in
a conventional environment or a TrainMaster Command Control environ-
ment. The headlight flickers as the locomotive searches for a signal from the Command
Base. When the locomotive has determined that a Command Base is not connected to the
track, the flickering will stop and the headlight will remain illuminated. You are ready for
operation in the conventional environment.
5. Move 'em out! Press the DIRECTION button on your transformer to sequence your
locomotive through the repeating pattern of operations: forward, neutral, reverse, neutral,
and so on. You may also briefly turn off track power to advance the locomotive to the next
operating state. Adjust the throttle until your locomotive moves at your desired speed.
When placing your locomotive on your layout for the first time, it will start out in
Note!
neutral. Thereafter, it will start in forward after every power interruption lasting five
seconds or longer.
Use the WHISTLE and BELL buttons on your transformer to activate those features. Refer
to page 16 if your transformer is not equipped with those buttons.
11