Installing The Hp 560; Unpacking The Product - HP 650 Installation Manual

2 Installing the HP 560

The HP 560 is designed for indoor installation on a desktop, wall, ceiling, or in a plenum. You
are responsible for ensuring that installation and use comply with local safety and radio regulations.
IMPORTANT:
in RF installation and knowledgeable in local regulations including:
Building and wiring codes.
Safety regulations.
Channel, power, and indoor/outdoor restrictions.
License requirements for the intended country of operation.
It is important to identify known RF absorbers, reflectors, and interference sources in the environment
while planing your installation.

Unpacking the product

Inspect the package contents and verify that they are free from defects. The package contains:
An HP 560.
An AP mounting bracket.
A padlock bracket.
Two sets of AP bracket T-bar clips with screws.
Two mounting screws with wall anchors.
A retention screw.
An adapter bracket. (If you are replacing an existing device with an HP 560, you can use
this bracket to connect the HP 560 mounting bracket to the existing mounting bracket.)
Documentation.
NOTE: The AP bracket is two-sided. Install the HP 560 on the side with the UP arrow. The other
side, with the T-bar clip screw holes, faces the wall or T-bar. The AP bracket is mounted first, and
then the HP 560 is attached to the bracket.
This device requires professional installation. Consult a professional installer trained
Unpacking the product 7