Removing The Hp 560 - HP 650 Installation Manual

Figure 6 Retention screw and padlock bracket
1. AP bracket
2. Retention screw
3. AP bracket lock tab

Removing the HP 560

To remove the HP 560 from the bracket:
1. Remove any locks and remove the retention screw.
2. While carefully holding the HP 560, insert a flat screwdriver into the cable channel between
the channel wall and the AP bracket latch, releasing the HP 560 from the bracket, while being
careful to retain grip on the HP 560 as you slide it away from the AP bracket lock tab.
3. Disconnect the Ethernet cable from the HP 560.
1
2
3
4. Padlock hole
5. AP padlock bracket
6. Cable lock hole
4
5
6
Removing the HP 560 1 1