www.freeservicemanuals.info
GB 22
4.
4.3.6
DAF Panel
1. Remove the fixation screw [1].
2. Push down the fixation clamp [2], and pull the complete
bracket at the same time away from the CRT [3]. The
module is now free from the LSP-bracket.
3. Release the fixation clamps [4], in order to remove the
print from its bracket.
Figure 4-10
4.3.7
Mains Switch / LED Panel
1. Release the two fixation clamps by pushing them upward
[1].
2. At the same time, pull the complete assy backward [2].
3. Now release the two fixation clamps [3], in order to
remove the print from its bracket [4].
1
4
2
Figure 4-11
Note: If necessary, you can replace the light guide.
EM3E
Mechanical Instructions
CL 16532044_011.eps
150501
3
3
1
CL 16532044_012.eps
090501
4.4
Rear Cover Assembly
Before you re-assemble the rear cover, perform the following
checks:
•
Check whether the mains cord is mounted correctly in
the guiding brackets.
•
Check whether all cables are placed in fixation clamps.
This is very important due to the large 'hot' area of the
set.