Table of Contents
Advertisement
How to use
Tub Level Alarm
2,3
1
3
<With the operation button off>
1
Press the
Preparation
Operation button.
1. Plug the bath drain.
The temperature will be indicated
on the display.
On
Previously set temperature
(example: 104°F)
14
Adjust temperature.
2
(
Check the
)
temperature if you will
not be changing it.
On
Hot
Cold
Check the indicator lights.
Water temperature
The alarm will sound for ten
seconds when the water
reaches the specified level.
(But the water will continue to run
unless it is manually turned off.)
<The setting is remembered>
3
4
Adjust tub level
setting.
Press the operation button (the level
setting indicator will flash) and then
the setting button.
Increase
Decrease
Set the water level of your tub, the
choices for settings are anything
between 10 and 65 gal., in increments
of 5, and 80, 90, 105 and 990 gal.
(Reference values)
The alarm will not sound if it
Note:
is set for 990 gal.
Water level will be flashing (ex. 45 gal.)
* The level can be adjusted while
the indicator is flashing.
* The temperature will return after
ten seconds.
• If water is being used besides what is needed for the tub, the alarm will sound before the set
level is reached in the tub.
• If there was water remaining in the tub, or if the water is not manually turned off after the
buzzer sounds, the tub may overflow.
• If there was water remaining in the tub, the temperature after the tub is filled the rest of the
way will be less than the set temperature.
Water temperature
The temperatures shown below are only examples. Your actual
reaction to set temperatures will depend on the season and the
length of piping.
99 100 102 104 106 108 109111 113 115 117 118
Warm
Warmer
Hot
* Initial factory setting at shipment: 104°F
Stop the hot
5
Run the hot
water when the
water.
alarm sounds.
The alarm will sound when
the specified level has been
reached. Stop the water.
The alarm will not
Note:
sound if it is set for 990
gal.
On
Off
15
Advertisement
Table of Contents
