Noritz N-063S Series Instruction Manual

Noritz N-063S Series Instruction Manual

Descale procedure group c
Hide thumbs Also See for N-063S Series:

Advertisement

This instruc onal manual is only intended for use by a qualified service professional or authorized Noritz
Service Representa ve. Any unauthorized use of this manual may result in voiding the warranty.
Please contact Noritz Technical Support (866-766-7489) for add onal support.
• N-042
• N-063
• N-084
• N-132
Rev. 06/16
Descale P
Group C
Applicable Models:
• N-063S Series
• N-069M Series
• N-084M Series
• N-132M Series
• N-0531S Series
• N-0631S Series
• N-0751M Series
• N-0841MC Series
• N-0842MC Series
• N-0931M Series
• N-1321M ASME
Noritz America Corpo
11160 Grace Avenue, Fountain Valley, CA 92708
Phone 866-766-7489 Fax 714-241-1196
rocedure
• NR50-OD
• NR66 Series
• NR71 Series
• NR98 Series
• NC199 Series
• NRC111 Series
• NCC199 Series
• NR111 Series
• NC250 Series
• NC380-SV-ASME
on
• NRC661 Series (Not A)
• NR83-DVC
• NRC83 Series
• NRC98 Series
• NR981 Series
• NC1991 Series
• NRC1111 Series
• NCC1991 Series
• NCC1992-DV
Pg. 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the N-063S Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Noritz N-063S Series

  • Page 1 Group C This instruc onal manual is only intended for use by a qualified service professional or authorized Noritz Service Representa ve. Any unauthorized use of this manual may result in voiding the warranty. Please contact Noritz Technical Support (866-766-7489) for add onal support.
  • Page 2 Damage to the water heater as a result of the items below is not covered by the Noritz America Limited Warranty. • Water in excess of 12 gpg (200mg/L) of hardness. • Poor water quality Note: Water so eners may be regulated by the local water jurisdic on, consult with the manufacturer for code, sizing, and install on guidelines;...
  • Page 3 Flushing Procedure C Gas Supply Valve Turn the power ON/OFF Button "on" on the remote controller, and then set temperature "140° " by pressing the UP Button. (It's for closing the "Water Servo-Bypass".) If your unit is N-132, N-132M, N-1321M or NC380 series, the temperature needs to be set at 145°F by pressing the UP Open the "V2 Valve"...
  • Page 4 13. Clean the water heater with fresh water for 3 minutes or more to rinse the flushing solution. For Condensing units only : Place a bucket under the water heater to drain water from the "Water Drain Valve". Carefully unscrew the "Water Drain Valve" to rinse the flushing solution, and then close it.

This manual is also suitable for:

Nrc661 seriesN-069m seriesNr66 seriesN-084m seriesNr71 seriesNrc83 series ... Show all

Table of Contents