Table of Contents
Advertisement
Turning the power on and off
If the MAIN POWER switch on the LCD Projector is turned off while the cooling fan is still operating, the operating life of
the projector lamp will be shortened. Be sure to follow the procedures given below when turning the LCD Projector
power supply on and off.
(LCD Projector)
POWER Button/
POWER Indicator
STANDBY(R) ON(G)
•
Turning on the power
1
OFF
MAIN
ON
2
or
(LCD Projector) (Remote Control
Unit)
•
Turning off the power
1
or
(LCD Projector) (Remote Control
Unit)
2
Wait for the cooling fan to stop.
3
Note
• Insert Power Cord into LCD Projector AC socket and connect to properly grounded wall outlet.
• If the power is turned off using the POWER button, the cooling fan will continue to operate while the inside of the
Projector is still at a high temperature. Do not turn the MAIN POWER switch to the OFF position, disconnect the power
cord plug from the wall socket or shut off the mains power supply until the cooling fan stops operating.
• If the MAIN POWER switch has not been turned off, the Projector will still draw approximately 20 W of power, even
when the POWER button has been turned off and the fan has stopped.
• To prevent the Lamp, when the power is turned off, the Lamp lights for just a moment as the cooling fan stops.
MAIN POWER Switch
Press the
Press the MAIN POWER switch on the LCD Projector to ON.
MAIN POWER
switch
The power indicator will illuminate red and the Projector will switch
to standby mode.
Press POWER button on the LCD Projector or remote control.
Press the
POWER button
The power indicator will illuminate solid green and a picture will be
projected onto the screen.
Note
The LCD Projector cannot be turned on for 60 seconds after
turning it off.
Press POWER button on the LCD Projector or remote control.
Press the
"Please press POWER button again to power off." is displayed on
POWER button
the screen, and then press POWER button again.
The power indicator will illuminate flashing red and the Projector
will switch to standby mode.
Wait for a while (approximately 2 minutes) until the power indicator
will illuminate solid red.
Press the
Press the MAIN POWER switch on the LCD Projector to OFF.
MAIN POWER
switch
The power indicator will switch off and the power supply will be
turned off.
(Remote Control Unit)
POWER Button
14
Advertisement
Table of Contents
