Table of Contents
Advertisement
Adjusting the LCD Projector Projection Angle
Adjusting the LCD Projection angle of the LCD Projector. When the projector is in the horizontal position, keystone
correction is unnecessary and a correct image can be viewed.
• Adjustment procedure
1
Lift the front of the LCD Projector to the desired angle. While
holding it in place, press the 2 adjuster buttons located under
the right and left sides of the projector. When the buttons are
pressed, the left and right adjustable legs will drop down until
they reach the setting-up surface.
Note
• Do not release the buttons until both legs have reached the
setting-up surface.
2
Release the adjuster buttons. (The adjustable legs will lock as
soon as the buttons are released.)
3
Turn the adjustable legs by hand in either direction to make
fine adjustments.
Note
• The legs can be extended by up to 52 mm. If you try to
extend them any further than this, they will merely spin
freely.
Retracting the adjustable legs
After lifting the front of the Projector slightly, press and hold the adjuster buttons and then gently lower the Projector.
Note
• Be sure to support the Projector firmly while pressing the
adjuster buttons. If the adjuster buttons are pressed
without supporting the Projector, the adjustable legs will
suddenly unlock and the Projector will fall down, which
could catch your fingers and damage the Projector.
Caution: When you set up the LCD Projector
• Do not place it in humid or dusty places, or places where the air is sooty or full of cigarette smoke. If the lens, mirror,
or other optical components become dirty, the picture will blur or darken, making viewing difficult.
• Do not expose to extreme heat or cold. Operating temperature: 0 C – 40 C (32 F – 104 F)
Adjuster button
Adjustable legs
Adjuster button
Adjustable legs
Adjuster button
52 mm
Adjuster button
15
Advertisement
Table of Contents
