Honda 1998 Prelude Owner's Manual page 206

1. Open the hood.
2. Remove the electrical connector
from the bulb by squeezing the
connector on both sides to unlock
the tab. Pull the connector straight
off.
HOLD-
DOWN
WIRE
WEATHER SEAL
3. Remove the rubber weather seal
by pulling on the tab.
4. Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way and remove the bulb.
5. Insert the new bulb into the hole,
BULB
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place and clip the end into
the slot.
6. Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked "TOP".
7. Push the electrical connector onto
CONNECTOR
the tabs of the new bulb. Make
sure it locks in place.
Turn on the headlights to test the
new bulb.
Lights
Maintenance