Honda 1998 Prelude Owner's Manual page 179

Cooling System
DRAIN BOLT
Except
Type SH
DRAIN PLUG
Except Type SH only
Remove the drain bolt and washer
from the engine block.
Maintenance
RESERVE TANK
HOLDER
4. Remove the reserve tank from its
holder by pulling it straight up.
Drain the coolant, then put the
tank back in its holder.
5. When the coolant stops draining,
tighten the drain plug in the
bottom of the radiator.
Except Type SH only
RESERVE
Apply non-hardening sealant to the
TANK CAP
drain bolt threads, put a new washer
on the drain bolt, and reinstall the
bolt in the engine block. Tighten it
securely.
Tightening torque:
61 Ibf . ft (83 N . m , 8.5 kgf . m)
6. Mix the recommended antifreeze
with an equal amount of purified
or distilled water in a clean
container. The cooling system
capacity is:
With 5-speed manual transmission:
(Except Type SH)
0.87 US gal (3.3 l , 0.73 Imp gal)
(TypeSH)
0.85 US gal (3.2 l ,0.70 Imp gal)
With automatic transmission:
0.85 US gal (3.2 l , 0.70 Imp gal)