Yamaha 2011 XVS1300AA Owner's Manual page 27

Right
1. Engine stop switch " / "
2. Hazard switch " "
3. "SELECT" switch " / "
4. "RESET" switch
5. Start switch " "
Pass switch " "
Press this switch to flash the headlight.
Dimmer switch " / "
Set this switch to " " for the high
beam and to " " for the low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
INSTRUMENT AND CONTROL FUNCTIONS
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
Start switch "
EAU12350
Push this switch to crank the engine
with the starter. See page 6-1 for start-
ing instructions prior to starting the en-
EAU12400
gine.
The engine trouble warning light will
come on when the key is turned to "ON"
EAU12460
and the start switch is pushed, but this
"
does not indicate a malfunction.
". When re-
Hazard switch "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
EAU12500
" turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
EAU12660
/ "
might be a traffic hazard.
" before starting
" to
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU12711
"
"SELECT" switch "
This switch is used to perform selec-
tions in the odometer and tripmeters, to
set the clock and to set the brightness
control mode of the multi-function
EAU41700
meter unit.
See "Multi-function meter unit" on page
4-6 for detailed information.
4-10
EAU12733
"
" posi-
ECA10061
4
EAU42524
/ "