Yamaha 2011 XVS1300AA Owner's Manual page 25

tomatically, and the display will return
to the prior mode after refueling and
traveling 5 km (3 mi).
To set the clock
1. Clock
1. Push the " " or "
"SELECT" switch to change the
display to the clock mode.
2. Push the " " side of the "SE-
LECT" switch and the "RESET"
switch together for at least two
seconds.
3. When the hour digits start flashing,
push the " " or "
"SELECT" switch to set the hours.
4. Push the "RESET" switch, and the
minute digits will start flashing.
INSTRUMENT AND CONTROL FUNCTIONS
5. Push the "
"SELECT" switch to set the min-
utes.
6. Push the "RESET" switch and then
release it to start the clock.
Self-diagnosis device
1
" side of the
1. Error code display
This model is equipped with a self-diag-
nosis device for various electrical cir-
cuits.
If a problem is detected in any of those
circuits, the engine trouble warning light
will come on and the odometer/tripme-
" side of the ter/clock display will indicate an error
code.
" or " " side of the If the odometer/tripmeter/clock display
indicates any error codes, note the
code number, and then have a Yamaha
dealer check the vehicle.
The self-diagnosis device also detects
problems in the immobilizer system cir-
cuits.
If a problem is detected in the immobi-
lizer system circuits, the immobilizer
system indicator light will flash and the
display will indicate an error code.
TIP
If the display indicates error code 52,
this could be caused by transponder in-
terference. If this error code appears,
try the following.
1. Use the code re-registering key to
TIP
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
4-8
start the engine.
4