Table of Contents
Advertisement
Remove spacers from the center panel.
Place the largest spacer on the pin that
would be below transmitter button when
the cover is closed. Close the cover.
144
When the garage door opener transmitter
is properly installed, you can operate the
transmitter by pushing the center panel of
the cover.
If the center panel does not contact with
your garage door opener transmitter:
D
Check to see if spacer is on correct
pin.
D
Attach another spacer to the top of
original spacer. Check operation. If re-
quired, continue add spacers until con-
tact is achieved.
If the transmitter is clattering during driv-
ing, fill in a piece of felt or pad to prevent
the transmitter from clattering.
Advertisement
Table of Contents
