Car Audio System Operating Hints; Radio Reception - Toyota 1998 Camry Owner's Manual

Table of Contents

Advertisement

TAPE
Push "TAPE" to switch from radio or com-
pact disc operation to cassette operation.
If the audio system is off, you can turn
on the cassette player by pushing "TAPE".
In both cases, a cassette must already be
loaded in the player.
TRACK
(Track
up/down
Compact disc player
By using this button, you can skip up or
down to a different track.
Push either side of the track button until
the number of the track you want to listen
to appears on the display. If you want to
return the beginning of the current track,
push the down side of the button one
time, quickly.
TUNE (Tuning)
Your Toyota has an electronic tuning radio
(ETR). Push and release the "∧" (up) or
"∨" (down) side of "TUNE" to step up or
down the station band. (If you hear a
beep, you held the button too long and
the radio will go into the seek mode.)
—Car audio system operating
hints
NOTICE
To ensure the correct audio system
operation:
z Be careful not to spill beverages
over the audio system.
z Do not put anything other than a
button):
cassette tape or Compact Disc into
the slot.

RADIO RECEPTION

Usually, a problem with radio reception
does not mean there is a problem with
your radio—it is just the normal result of
conditions outside the vehicle.
For example, nearby buildings and terrain
can interfere with FM reception. Power
lines or telephone wires can interfere with
AM signals. And of course, radio signals
have a limited range, and the farther you
are from a station, the weaker its signal
will be. In addition, reception conditions
change constantly as your vehicle moves.
Here are some common reception prob-
lems that probably do not indicate a prob-
lem with your radio:
FM
Fading and drifting stations—Generally, the
effective range of FM is about 40 km (25
miles). Once outside this range, you may
notice fading and drifting, which increase
with the distance from the radio transmit-
ter. They are often accompanied by distor-
tion.
Multi−path—FM
signals
are
making it possible for two signals to reach
your antenna at the same time. If this
happens, the signals will cancel each oth-
er out, causing a momentary flutter or
loss of reception.
Static and fluttering—These occur when
signals are blocked by buildings, trees, or
other large objects. Increasing the bass
level may reduce static and fluttering.
Station swapping—If the FM signal you
are listening to is interrupted or weak-
ened, and there is another strong station
nearby on the FM band, your radio may
tune in the second station until the origi-
nal signal can be picked up again.
reflective,
131

Advertisement

Table of Contents
loading

Table of Contents