Table of Contents
Advertisement
384
6-4. Other interior features
3
Press and hold the vehicle's programmed HomeLink
2 seconds and release it. Repeat this step once again. The
garage door may open.
If the garage door opens, the programming process is complete. If the
door does not open, press and release the button a third time. This third
press and release will complete the programming process by opening
the garage door.
The ceiling mounted garage door opener motor should now recognize
the HomeLink
4
Repeat the steps above to program another rolling code system
for any of the remaining HomeLink
■
Programming an entry gate (for U.S.A. owners)/Programming a
devices in the Canadian market
1
Place the remote control transmitter 1 to 3 in. (25 to 75 mm)
away from the HomeLink
Keep the HomeLink
2
Press and hold the selected HomeLink
3
Repeatedly press and release (cycle) the remote control trans-
mitter for 2 seconds each until step
4
When the HomeLink
release the buttons.
5
Test the HomeLink
grammed button. Check to see if the gate/device operates cor-
rectly.
6
Repeat the steps above to program another device for any of the
remaining HomeLink
■
Programming other devices
To program other devices such as home security systems, home
door locks and lighting, contact your Toyota dealer for assistance.
■
Reprogramming a button
The individual HomeLink
reprogrammed. To reprogram a button, follow the "Reprogramming
a HomeLink
®
signal and operate the garage door.
®
®
indicator light in view while programming.
®
indicator light starts to flash rapidly,
®
operation by pressing the newly pro-
®
buttons.
®
buttons cannot be erased but can be
®
button" instructions.
®
buttons.
buttons.
®
button.
4
is completed.
®
button for
Advertisement
Table of Contents
Troubleshooting
