Yamaha 2006 YZF-R6V Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
G
a speedometer (which shows the
riding speed)
G a tachometer (which shows engine
speed)
G an odometer (which shows the to-
tal distance traveled)
G
two tripmeters (which show the
distance traveled since they were
3
last set to zero)
G a fuel reserve tripmeter (which
shows the distance traveled since
the fuel level warning light came
on)
G
a stopwatch
G
a clock
G a coolant temperature display
G an air intake temperature display
G
a self-diagnosis device
G
a display brightness and shift tim-
ing indicator light control mode
NOTE:
Be sure to turn the key to "ON" before
using the "SELECT" and "RESET" but-
tons.
Tachometer
1. Tachometer
2. Tachometer red zone
The electric tachometer allows the rider
to monitor the engine speed and keep it
within the ideal power range.
When the key is turned to "ON", the ta-
chometer needle will sweep once
across the r/min range and then return
to zero r/min in order to test the electri-
cal circuit.
CAUTION:
Do not operate the engine in the ta-
chometer red zone.
Red zone: 17500 r/min and above
3-8
Clock mode
1. Clock
Turn the key to "ON".
To set the clock
1. Push the "SELECT" button and
"RESET" button together for at
least two seconds.
2. When the hour digits start flashing,
push the "RESET" button to set the
hours.
ECA10031
3. Push the "SELECT" button, and
the minute digits will start flashing.
4. Push the "RESET" button to set
the minutes.
5. Push the "SELECT" button and
then release it to start the clock.