Coleman xt260 Owner's Manual page 73

14. BATTERY
Battery Removal
1. Disconnect hold down straps holding the electrical box and
battery in position and remove battery cover.
2. Remove the battery vent tube from the battery.
3. Disconnect the black (negative) battery cable first.
4. Disconnect the red(positive) battery cable next.
5. Lift the battery out of the ATV, being careful not to tip it
sideways and spill electrolyte.
CAUTION
If electrolyte spills, immediately wash it off with a solution of one
tablespoon baking soda and one cup water to prevent damage to
the ATV.
Battery Installation and Connections
WARNING
To avoid the possibility of explosion, always connect battery
cables in the order specified. Red (positive) cable first; black
(negative) cable last. An exploding battery can cause serious
injury or death.
Battery terminals and connections should be kept free of
corrosion.
If cleaning is necessary, remove the corrosion with a stiff wire
brush. Wash with a solution of one tablespoon baking soda and
one cup water. Rinse well with tap water and dry off with clean
rags. Coat the terminals with dialectic grease or petroleum jelly.
Be careful not to allow cleaning solution or tap water into the
battery.
67