KVH Industries TracPhone V11-IP Installation Manual page 36

20 Continued
Standard Configuration
In a standard configuration, all four User
Ethernet ports and the built-in WAP provide
direct Internet access without a user login. This is
the default configuration. Follow these
additional steps to configure the network.
a. To enable the ICM's WAP for wireless access,
follow the steps in "ICM Wireless Settings"
on page 39.
b. Connect the customer's computers and/or
other network devices to the ICM (see
Figure 68). For example, you might wish to
add an external WAP (or Wi-Fi router
configured for bridge mode) to supplement
Wi-Fi access.
c. Make sure all computers are configured for
DHCP addressing (see page 47). Devices
connected to the ICM (via Ethernet cables or
Wi-Fi) will receive IP addresses from the ICM
via DHCP (see Figure 68). The ICM serves as
a router.
NOTE: By default, the ICM has a gateway of
192.168.5.1 and assigns IP addresses in the
192.168.5.100-200 range. If this configuration
conflicts with an existing onboard network, you may
change the settings at the TracPhone V11-IP web
interface (go to Settings > Network Settings).
Configure the Network
Figure 67: Standard Configuration
Figure 68: Standard Configuration Wiring Example
ICM
User Ethernet
LAN: 192.168.5.1
192.168.5.100
Bridge PC
1 2 3 4
192.168.5.102
WAP
192.168.5.101
Officers PC
Mobile
Devices
192.168.5.103
35