Mount The Icm - KVH Industries TracPhone V11-IP Installation Manual

5

Mount the ICM

There are two options for mounting the ICM:
Option 1 - Inside an equipment rack
Option 2 - To a horizontal surface
NOTE: You may choose to wait to mount the ICM
until after you have completed all system wiring.
Option 1 – Rack Mount
The ICM is sized to fit a standard 19" (48.26 cm)
rack, occupying 2U of space. Follow these steps
to secure the ICM in an equipment rack.
a. Attach the supplied strain-relief bracket to
the back of the ICM using four supplied #6-32
screws and washers (see Figure 8).
b. Insert the ICM into the rack and secure its
front mounting brackets to the rack using
four M6 screws and washers (see Figure 9).
Option 2 – Horizontal Surface Mount
Follow these steps to mount the ICM to a
horizontal surface.
a. Remove the six #6-32 screws and washers
securing the two rack-mount brackets to the
front of the ICM (see Figure 10). Remove the
brackets.
b. Attach the supplied strain-relief bracket to
the back of the ICM, and attach the supplied
"L" mounting brackets to the sides of the
ICM, using six supplied #6-32 screws and
washers (see Figure 11).
c. Mount the ICM to the vessel using fasteners
appropriate for the mounting surface.
Figure 8: Attaching the Strain-Relief Bracket
Tie-Wrap Strain-Relief
Holes (x42) Bracket
Figure 9: Securing the ICM in the Rack
Figure 10: Removing the Rack-Mount Brackets
Figure 11: Attaching the Mounting and Strain-Relief Brackets
#6 Washer (x6)
#6-32 Screw (x6)
Mounting Bracket (x2)
Ø.156" (Ø3.96 mm)
Mounting Hole (x4)
#6 Washer (x4)
#6-32 Screw (x4)
Plastic Washer (x4)
M6 Screw (x4)
Bracket (x2)
#6 Washer (x6)
#6-32 Screw (x6)
Strain-Relief Bracket
9