Wire The Icm - KVH Industries TracPhone V11-IP Installation Manual

12

Wire the ICM

Follow these steps to wire the belowdecks
equipment (see page 52 for a complete wiring
diagram).
Connect the Antenna Data Cable
a. Connect the antenna data cable to the
supplied 16-position terminal strip connector
as shown in Figure 40.
IMPORTANT!
The diagram refers to wires by body color/
stripe color. For example, "Brown/White"
means the brown wire with white stripe.
b. Place the terminal strip connector into the
base of the supplied cable shroud as shown in
Figure 41.
c. Secure the end of the data cable to the base of
the shroud using the supplied clamp. This
clamp will help relieve stress on the cable.
Secure the clamp in place with the two
screws.
d. Carefully fit all of the data cable's wires
within the base of the shroud.
e. Snap the shroud's cover onto the base. Be
sure not to pinch any wires between the cover
and the base.
f. Plug the terminal strip connector into the rear
panel of the ICM.
g. Connect the data cable's ground wire
(attached to the grounding sleeve) to the
ground screw on the rear panel of the ICM
(see Figure 40).
Figure 40: Antenna Data Cable Wiring
ICM
Grounding
Sleeve
1 2 3 4
Red
Black
White/Gray
Gray/White
White/Orange
Orange/White
White/Brown
Brown/White
White/Blue
Blue/White
White/Green
Green/White
Red/Orange
Orange/Red
Red/Green
Green/Red
Figure 41: Data Cable Shroud
Antenna
Terminal Strip Connector
5 6 7 8 9 10 11 12 13 14 15 16
Cover
Terminal Strip Connector
Base
Clamp
Data Cable
23