Table of Contents
Advertisement
6.5
Installation recess
The refrigerator must be installed draught-free in a recess (see "6.2").
The measurements of the recess are given in the table below.
Push the appliance far enough into the recess until the front edge of the refrigerator
casing is flush with the front of the recess. Allow a gap of 10-20 mm between the back
wall of the recess and the refrigeration unit. The floor of the recess must be level, allo-
wing the appliance to be pushed easily into its correct position. The floor must be sub-
stantial enough to bear the weight of the appliance (no hollow space underneath).
Ensure that the refrigerator is installed level in the recess.
Recess measurements:
Stopper strips for example are affixed
in the installation bay, at the sides, at
the bottom and at the top and are fitted
with flexible sealant strips
6.6
Securing the refrigerator
Width of recess = W
Width of recess = W
Model
RM 7601 / RM 7605
RM 7651 / RM 7655
RM 7801 / RM 7805
H
RM 7851 / RM 7855
T
Hight H
1248 mm
1248 mm
1248 mm
1248 mm
Affix strip to side wall.
Seal i.e.V seal.
plan view
In the sidewalls of the refrigerator, there are four plastic
sleeves with screws for securing the refrigerator. The
sidewalls or rails attached for securing the refrigerator
must be designed in such a way that the screws will
remain firmly in place even when under increased load
(while the vehicle is moving).
Always insert screws through the sleeves provided;
otherwise, structural parts embedded in the foam,
such as cables, etc., may be damaged.
Once the refrigerator is in its final position, secure the
screws into the wall of the recess.
22
Width W
Depth T
530 mm
510 mm
530 mm
510 mm
530 mm
565 mm
530 mm
565 mm
The screws must penetrate
through the sheet metal
casing of the refrigerator.
Hide quick links:
Advertisement
Table of Contents
