Message Codes; Care; Safety Instructions; Areas Of Responsibility - Makita LD080PI Instruction Manual

Message Codes

If the message Error does not disappear
after switching on the device repeatedly,
contact the dealer.
If the message InFo appears with a
number, press the Clear button and
observe the following instructions:
No. Cause Correction
156 Transverse tilt Hold the instrument
greater than 10° without any transverse
tilt.
162 Calibration mistake Make sure, the device
is placed on a abso-
lutely horizontal and flat
surface. Repeat the
calibration procedure. If
the mistake still occurs,
contact your dealer.
204 Calculation error Perform measurement
again.
252 Temperature too Let device cool down.
high
253 Temperature too Warm device up.
low
255 Received signal too Change target surface
weak, measuring (e.g. white paper).
time too long
256 Received signal too Change target surface
high (e.g. white paper).
257 Too much back- Shadow target area.
ground light
258 Measurement Correct range.
outside of meas-
uring range
260 Laser beam inter- Repeat measurement.
rupted

Care

• Clean the device with a damp, soft cloth.
• Never immerse the device in water.
• Never use aggressive cleaning agents
or solvents.
Makita LD080PI

Safety Instructions

The person responsible for the instrument
must ensure that all users understand
these directions and adhere to them.

Areas of responsibility

Responsibilities of the manufacturer
of the original equipment:
Makita Corporation Anjo,
Aichi 446-8502 Japan
Internet: www.makita.com
The company above is responsible for
supplying the product, including the User
Manual in a completely safe condition.
The company above is not responsible for
third party accessories.
Responsibilities of the person in
charge of the instrument:
• To understand the safety instructions on
the product and the instructions in the
User Manual.
• To be familiar with local safety regula-
tions relating to accident prevention.
• Always prevent access to the product by
unauthorised personnel.
EN
17