Advertisement
Available languages
Available languages
5.- FIRE up the firewood or the kindling.
6.- Shut the door when the firewood is burning. The model always must work with the door closed
7.- When the combustion stabilizes, control the fire using the primary air vents.
8.- Follow the instructions below on regulating the fire.
IV - REGULATION OF THE FIRE
In order to control the fire and avoid the escape of smoke, it is essential to keep the combustion chamber closed. Only open the chamber to add more wood.
Remember that the appliance and its exterior will be very hot during the combustion process. Do not touch any surfaces close to it.
Keep inflammable materials at least 150 cm away from the fire.
The stove has got two air intakes: primary and secondary. The primary air intake controls the combustion. If closed, there will be a slow and economical fire; if opened there
will be quick and high calorific fire. (See figure 1).
Secondary air
intake controls
Primary air intake
control
DENIA – GRANADA
VALLE – BRITO
Secondary air intake: it reduces pollution levels and also creates a draft of air close to the glass, helping to keep it
clean. Move it to the left to close it, or to the right to open it. (See figure 2).
NOTE: It is very important to use suitable gloves or a hook to manipulate the controls of air intake, primary or
secondary, because the surface will be very hot during the combustion process.
V - POSITIONING THE WOOD HOLDER
Install the wood holder. This is a removable piece. Insert the piece into the firebox and fit it in the notches placed in the
base (see figure 3).
VI - PECULIAR TO STOVES DENIA, GRANADA & NERJA (CERÁMICA)
FITTING THE PIECES OF CERAMIC
In case you need to remove the pieces of ceramic, follow the instructions
given below:
1 - Remove the upper lid by pulling up.
2 - Then, unscrew the screw situated under this lid, which hold the back
panel of the stove to the main body of the appliance. Do not unscrew
completely, one and a half turn is quite enough. Otherwise, the back panel
could not be supported anymore, could fall and break.
3 - Take the ceramic pieces off pulling them up, without bending it and
holding them firmly.
4 - When replacing the ceramic pieces again, let them slide gently to the
bottom without releasing them. Once every part is placed, screw the screws at
the same time pushing the back panel to the front (see figure 5).
5 - And finally put the top in its place.
3. EXTRACT THE
CERÁMIC PART
PRIMARY AND SECONDARY AIR INTAKES
NERJA – FORNO
1. TOP REMOVAL
4. REPOSITION
FIGURE 2
DURCAL – GUADIX – BELEN
MARTA – ROSSY
TORNILLOS SUJECIÓN
Screws holding the back
PANEL TRASERO
panel
2. UNSCREW THE SCREWS
5. AJUSTMENT OF
THE LID
FIGURE 5
ENG
LAWA
FIGURE 3
TORNILLOS SUJECIÓN
Screws holding the
PANEL TRASERO
back panel
FIGURE 4
8
Advertisement
