Product Specifications; Tools And Materials Required For Installation - GE Smart Water PNRV18ZWH01 Installation Instructions Manual

Feed water pressure limits—pounds per square inch (psi)
Feed water temperature limits—minimum/maximum degrees F
Maximum Total Dissolved Solids (TDS)—parts per million (ppm)
Maximum water hardness @ 6.9 pH—grains per gallon (gpg)
Maximum iron, manganese, hydrogen sulfide (ppm)
Chlorine in water supply
Feed water pH limits (pH)
Product (quality) water, 24 hours—gallons
Process water per gallon of product water, 24 hours—gallons
Percent rejection of TDS (new membrane)
Cyst reduction
Storage tank capacity—gallons
Automatic shutoff control
Prefilter and postfilter (# FX18P)
Reverse Osmosis membrane (# FX18M)
Dimensions (inches)
a. As tested by Water Quality Association standard "S-300." Output according to ANSI/NSF Standard 58 is 10.9 gallons per day for the
Reverse Osmosis 18 model. Feed water at 50 psig and 77 °F with 750 parts per million sodium chloride. Quality water production,
amount of waste water and percent rejection all vary with changes in pressure, temperature, and Total Dissolved Solids.
b. Removed (maximum of 2.0 ppm) by the Reverse Osmosis prefilter. REGULAR MAINTENANCE IS REQUIRED. Chlorine will
destroy the Reverse Osmosis membrane.
c. If house water pressure is over 125 psi, install a pressure reducing valve in the water supply line.
If house water pressure is under 40 psi, install a Reverse Osmosis booster pump (contact your local plumbing supply company).
• Cordless Drill
• 1 ⁄ 4 " Drill Bit
• 1-1 ⁄ 4 " Carbide Hole Saw (if needed—see page 6)
• Adjustable Open-End Wrenches
• Phillips and Straight Screw Drivers
• Utility Knife
• Teflon Tape
TM
• Contents Included with the Product:
— Reverse Osmosis Assembly
— Product Literature (Installation Instructions, Owner's Manual, Performance Data Sheet, and Owner Registration Card)
— Faucet Base Parts Bag
— Battery and Holder Parts Bag
— Water Supply Valve Parts Bag
— Drain Line Adapter
— 27" Length of 3 ⁄ 8 " Tubing
INSTALLER RESPONSIBILITY: The water supply valve (page 4) is included for use in areas where codes permit. Installer must comply
with state and/or local codes. If not, the installer must provide fittings to tap the cold water pipe for a feed water source to the Reverse
Osmosis system (must adapt to 1/4" OD tubing).
MODEL PNRV18Z PRODUCT SPECIFICATIONS

TOOLS AND MATERIALS REQUIRED FOR INSTALLATION

Carbon block and granular activated carbon
Thin film polyamid
Height Width
21 8
2
c
40–125
40–100
2000
10
<0.1
b
allowable
4–10
a
18.0
a
4
a
92
99.95%
1.9
yes
Depth
10