Advertisement
Inspection and adjustment before flying
1. Switch for power supply: Install 8 cells into the transmitter according to the symbol of
battery's polarity, then turn on the transmitter. Install the full charged flight battery into the battery
compartment of the fuselage, and connect the plug of battery with the electronic Speed Controller.
To make sure the radio control system is working well, you should follow the instruction: turn on the
transmitter before flying (connecting the battery with ESC plug); and turn off the power for receiver
first when stop operation (pulling out battery and ESC plug), then turn off the transmitter.
2. The right joystick of transmitter controls the aileron by turning left or right: when you push the
joystick on the left, the left aileron of plane will turn up and the right aileron of plane will turn down in
response to your action, vice versa. Before flying, put the trim of aileron to the middle position, and
then adjust the both ailerons to the neutral position with the clevis.
3 The movement of the left joystick in the transmitter controls the power of motor. When holding the
fuselage of the plane, please keep other objects away from the propeller in case of hurting people or
damaging the propeller. If you push the left joystick in the lowest position, the power of the motor will
cease. Now the motor is on standby. You could check the performance of the motor by pushing the
joystick up slowly.
4. The up and down of the right joystick of transmitter controls the movement of the elevator. When you
push the joystick down, the elevator of plane will be flying up, vice versa. The best state before
flying is the elevator, joysticks and trim are all in the neutral position.
5. The left joystick in transmitter control the rudder: when you push the joystick on the right, the
rudder of plane will turn right in response to your action, vice versa. Rudder, joystick trim should be
in the middle before flying.
6. If the servos and motor give no response during the adjustment, please check the connection of the
servos and ESC and make sure the battery is fully charged.
7. Check the CG of the model. The proper CG position should be 75~85mm away from the leading
edge, please refer to the picture. If in any doubt contact your dealer.
Note: The transmitter and receiver should be used in the same set but not be mixed and used with
other products.
(Picture for CG)
Advertisement
