Alarm Notice; Alarm Image Readout - Panasonic WJ-NT104 Operating Instructions Manual

ALARM NOTICE

The WJ-NT104 can notify the user of an alarm event.
The notice is sent either by Panasonic original protocol,
e-mail (SMTP client) or a combination of both.
E-Mail Notice
Mail is sent to the mail server using SMTP (Simple Mail
Transfer Protocol).
16 mail addresses can be specified.
• Mail contents include the URL to access the alarm
image, date and time (hours, minutes, seconds) of
the alarm, camera channel, and connection port
ID.
• If mail is not sent to the mail server before the set
timeout, the mail is automatically deleted.
• In case of continuous recording [after/before], mail
contents are as follows:
[Explanation]
NT104:
Host name set by network setup (8 characters
maximum). Default setting is WJ-NT104.
Date and time of alarm activation:
Based on the time of the internal clock of the
WJ-NT104.
Generating port:
Port number of the alarm input/output terminal
where an alarm is generated
Link to alarm image:
Alarm image URL. In continuous recording
mode, the URL of the first image. In the follow-
ing cases, accessing the URL may not display
the alarm image.
q Alarm image is overwritten.
(For the number of alarm images recorded see
page 38.)
w Alarm log is overwritten.
(Up to 100 alarm logs can be recorded.)
e NT104 is restarted due to a change in settings.
r Power is switched back on or the reset button
is pressed.
Number of frames recorded:
Number of alarm images to be recorded.
None in case Single Frame Recording
mode.
[Example]
!!! ALARM NOTICE !!!
Source : 133. 185. 10. 47 (NT104)
Port : PI0 5ch
Date : Jul/04/99
Link : http://133. 185. 10. 47/ALM0001_00.JPG
<NUMBER OF FRAMES RECORDED>
Total : 14
Before : 4
After : 10
39
Panasonic Original Protocol Notice
(option)
This is a special protocol based on the TCP/IP protocol
used to notify the users of an alarm.
If an alarm is activated, an alarm notice is sent to the
PC IP addresses set for the WJ-NT104 as alarm notice
recipients.
• To receive alarms, you need to install the special
alarm receiving software for the WJ-NT104 (option)
on your PC. Your PC must be kept powered up
and connected to the WJ-NT104 via a LAN.
• Up to 16 alarm notice destinations can be speci-
fied for the WJ-NT104.
Note
If the PC on the alarm receiving end does not respond
after a specified number of connection retries because it
is not powered up or for some other reason, the WJ-
NT104 sends the alarm notice to another PC registered
as an alarm notice recipient.

Alarm Image Readout

Recorded alarm images can be read out by accessing
the alarm list (almindex.html) of the WJ-NT104.