Table of Contents
Advertisement
Other operations for connection
Searching by unit's ID
Even if there are two or more units with the same name, an ID ([Disp] + 4-digit number) is assigned to each unit to enable the
units to be identified. When you click [ID Search], a search for the unit of the specified ID is carried out from among the units
that are presently switched on, from all channels other than [U].
It is necessary to know ID in advance. If you write down the ID displayed on the "Select Access Port" window in advance, you
can search a unit by the ID from next time.
1
Click [
] on the launcher.
The window shown to the right appears.
2
Click [ID Search].
The window shown to the right appears.
3
Enter four figures of desired unit's ID (Enter only a 4-digit number), and click
[Search].
Start Searching.
4
When the unit of the applicable ID is found, the computer will be connected to that
unit, and the status display of the launcher will turn green.
If appropriate ID is not found, an error message appears.
(cont.)
21
Advertisement
Table of Contents
