Factory Reset The House Code - RadioLink Ei168RC Instruction Manual

Factory reset the house code

Sometimes in order to resolve an RF
communication issue, it may be necessary to reset
HOUSE CODE SWITCH
(factory reset) and house code the system again.
To reset each RadioLINK base insert and hold
a screwdriver into the house code slot on the
base as shown here. The blue light will come on
solid. Hold the screwdriver in position until the
BLUE LIGHT
blue light starts to flash (6 seconds approx.) and
then release the screwdriver. When all devices
have been factory reset you can then start a new
house code procedure. To factory reset other
RadioLINK devices consult their manuals.
CAUTION: This is not the same procedure as entering and exiting house code.
16